BEKO Refrigerator Error Codes|Error Solution

BEKO Refrigerator Error Codes|Error Solution

The temperature performance of the refrigerating compartment reflects the fault of the refrigerator. The indicator indicates the temperature of the cold store, if it is lit, not blinking. The temperature indicator flashes when the control unit detects a fault. Malfunction alarms are deactivated only when the control system is switched to automatic test mode or when fault prevention is performed. BEKO Refrigerator Error Codes|Error Solution
Uses the automatic test mode of the refrigerator for diagnosis. To enable this function, you must simultaneously press and hold the camera selection and quick freeze button for 2 seconds. The test mode enters within 10 seconds after turning on the refrigerator. Automatic testing stops when a fault is detected.

2 cooling defects.
Refrigerant leakage, compressor malfunction, fan failure in refrigerator, improper sensor operation, prolonged exposure time.

3 heater fault.
Heaters do not work or do not work at full capacity, refrigerator sensors must be repaired.

4 sensor circuit is open.
One of the sensors is not installed, a malfunction in the wiring, a bad contact on the connectors

5 sensor short-circuit.
Sensor malfunction, defect of wires connecting one of 3 temperature sensors with control board, poor contact in connectors.

6 buttons are pressed.
Defective button, dirty button.

7 Compressor malfunction.
Compressor does not work, refrigerant leaks, obstruction of circulation system.

12 switch circuit faults.
Poor contact on the switch, in places connecting the wiring to the control board or switch, high resistance of wiring.

After troubleshooting, the test should be repeated first.

Beko AC Error Codes|Fault Code

Voltas Inverter Air Conditioner Error Codes